2010-2012 Hyundai Genesis 3.8L Cat Delete Pipes

$169.00
[Genesis 3.8L Cat Delete Pipes]

Installation was a breeze. It took about an hour from tear down to clean up. I did notice a little better throttle response, ant the exhaust is a little louder. This is a great mod for anyone who wants to keep the factory look, but wants to add a few HP. The only downside to this is that there is a raspy exhaust noise at start up when the engine is cold, but it goes away when the engine warms up. For installation all you need is a 19mm socket to take the factory nuts off, and a long flat head screw driver to pry the factory cat off. Be sure to save the exhuast flange gaskets on the factory cat so you can put them on the delete pipes. To install, all you need is a 17mm short socket for the bolts, and a 14mm short socket for the nuts. Be sure it is a short socket or a wrench cause the is hardly any room when tightening the top rear bolts. I would defiantly recommend buying this!
Date Added: 08/24/2010 by Anthony Lacey
Copyright © 2014 Road Race Motorsports.
Your IP Address is: 54.90.158.245
wastrong template